How to Tie the Arbor Knot: Attach Line to Your Reel Spool
Tie line to the reel spool with the arbor knot, stop braid slipping on the spool, and spool up correctly.
Every reel needs line attached to the spool, and that first knot matters more than people think. A poorly tied spool knot lets the line spin around the spool, especially with slippery braid, and you cannot retrieve line under load. The arbor knot is the standard knot for attaching line to a reel spool. This guide explains how to tie it and how to stop braid slipping.
Why the arbor knot
- Simple and fast.
- Tightens around the spool as you pull.
- Small and neat, so it does not create a bump under the line.
It does not need to be extremely strong, because you should never fish down to the last turns of line. But it must grip the spool.
How to tie the arbor knot
Open the bail and pass the line around the reel spool, with the tag end coming back toward you.
Tie an overhand knot with the tag end around the main line.
Tie a second overhand knot in the very end of the tag, about 2 cm from the first. This is the stopper.
Wet the knots and pull the main line: the first knot slides down and grips the spool, the stopper jams against it.
Trim the tag close so it does not make a bump under the line.
On spinning reels, make sure the bail is open when you pass the line around the spool, then close it before winding.
Stopping braid from slipping
Braid is so slick that even a tight arbor knot can spin on a smooth spool. Solutions:
- Mono backing: tie 10 to 20 m (or more) of mono to the spool with an arbor knot, then join the braid with a double uni knot or Albright knot. Mono grips the spool. See line capacity and backing.
- Tape: a strip of electrical tape around the spool before tying gives grip.
- Rubber band trick: a thin band around the spool under the first wraps.
- Many reels have rubber gaskets on the spool designed for braid.
Spooling after the knot
- Wind the line on under firm, even tension.
- On spinning reels, make sure the line comes off the filler spool in the same direction it goes onto the reel, to avoid twist.
- Fill to 2 to 3 mm below the lip.
Read how to spool a spinning reel.
Common mistakes
- Tying the arbor knot with the bail closed on a spinning reel, so the line does not pass under the roller.
- Tying braid directly to a bare spool.
- Leaving a long tag that creates a bump.
If you ever see the spool turning but no line coming in, the line is slipping on the spool. Stop, cut the line and re-spool with backing or tape.
Identify your catch with ReelScan: snap one photo to get the species, size and safety notes, and earn points. Scan a fish.
Summary
The arbor knot attaches line to the reel spool quickly and neatly. Add a stopper knot, moisten and pull it tight, and use mono backing or tape under braid to stop slipping. Then spool up with firm tension and the correct fill level.