Skills & gear › Hooks & tackle
Split Rings and Solid Rings: How to Rig Lures That Do Not Fail
Split rings, solid rings and welded rings explained: strength ratings, sizes, split ring pliers and rigging jigs and plugs safely.
On a popping lure, a jig or a plug, the hooks are connected with split rings and solid rings. These small rings are often the weakest part of the rig. When they open or break, you lose the fish and the lure. This guide explains the types of rings, strength ratings, sizes, and how to rig lures safely.
Split rings
A split ring is a flat, double-coiled ring like a key ring. You open it to slide onto a lure eye or hook.
- Uses: attaching hooks to plugs, connecting assist hooks to jigs, attaching lures to solid rings.
- Strength: rated in pounds or kilograms; heavy-duty rings can hold 100 to 400 lb.
- Material: stainless steel is best for saltwater; cheap plated rings rust and weaken.
Choosing split rings
- Match the ring strength to the hooks and the line.
- Use the strongest ring that fits the lure eye and hook without changing the action.
- Replace stock rings on cheap lures; they are often weak.
Solid rings
A solid ring is a welded, closed ring with no gap. It cannot open.
- Uses: the connection point for leaders and assist hooks on jigs and poppers.
- Strength: usually stronger than split rings of the same size.
- Standard jigging setup: leader tied to a solid ring, solid ring attached with a split ring to the jig, assist hook cords also on the solid ring.
Welded rings and oval rings
- Welded rings: another name for solid rings.
- Oval rings and figure-eight rings: used in some trolling rigs and heavy assist setups.
Split ring pliers
Split ring pliers have a small tooth on one jaw that opens the ring. They save your fingernails and make lure rigging fast. Most fishing pliers include a split ring tip. See fishing pliers and tools.
How to rig a jig correctly
- Tie the leader to a solid ring using a strong knot (a Palomar knot or a San Diego jam knot).
- Attach the assist hook cords to the same solid ring.
- Attach a split ring to the solid ring and then to the jig's eye.
This way the jig hangs free and the fish pulls on the solid ring, not the jig. Read assist hooks for jigging.
How to rig a popper or stickbait
- Replace trebles with strong inline singles on heavy split rings. See treble hooks vs single hooks.
- Attach the leader to the front with a solid ring and split ring, or tie directly to the lure eye.
Common mistakes
- Weak stock rings left on lures used for big fish.
- Rings too small, which open under load.
- Rings too large or heavy, which change lure action.
- Rusty rings, which can snap without warning.
- Leaving the ring partly open after attaching it.
Maintenance
- Rinse lures and rings with fresh water after every trip.
- Check rings after each big fish.
- Replace any ring that shows rust or deformation.
See how to store fishing lures.
Run the split ring all the way around until the hook sits fully inside the coils. A hook caught between the coils pops out the moment a fish pulls.
Identify your catch with ReelScan: snap one photo to get the species, size and safety notes, and earn points. Scan a fish.
Summary
Use solid rings as the main connection point, strong stainless split rings to attach hooks and jigs, and the right pliers to fit them. Match ring strength to your fish and check them often. Strong rings mean you keep the fish and the lure.