Skills & gear › Hooks & tackle
Assist Hooks for Jigging: Single, Double, Top and Bottom Rigging
Assist hooks explained: why jigs use them, single vs twin assists, cord length, top vs bottom rigging and sizes for each jig weight.
On a metal jig, the hook is not attached to the bottom like on most lures. Jigging uses assist hooks: hooks tied to a short piece of strong cord and attached to the top of the jig. This guide explains why assist hooks work, single vs twin assists, cord length, top and bottom rigging, and the right hook size for each jig weight.
Why assist hooks are used
- Fewer snags: hooks at the top of the jig catch the reef much less often.
- Better hook-ups: fish usually attack the head of the jig; assist hooks sit right there.
- Less leverage: the hook is not attached rigidly to a heavy jig, so the fish cannot use the jig's weight to shake the hook free.
- Fewer tangles with the leader during the fall.
Parts of an assist rig
- Hook: a strong, short-shank J hook or a light jigging hook.
- Assist cord: braided Kevlar or PE cord, often with a core.
- Solid ring: connects the cord to the leader and the jig.
- Split ring: connects the solid ring to the jig's eye.
See split rings and solid rings.
Single vs twin assist hooks
- Single assist: one hook. Simpler, fewer tangles, easier to unhook fish.
- Twin (double) assist: two hooks on separate cords. Higher hook-up rate, especially on slow pitch jigs where fish bite from the side.
Many anglers use twin assists on slow pitch jigs and single or twin on speed jigs.
Cord length
- Speed jigging: the hook point should sit around one third down the jig.
- Slow pitch jigging: shorter cords so the hook sits near the head and does not foul the jig as it flutters.
- Cords that are too long cause the hook to wrap around the jig or leader.
Top and bottom rigging
- Top only: the standard and best for most situations.
- Top and bottom: extra hook at the tail for fish that bite the back of the jig, like some tunas and mackerels. More snags and tangles over reef.
- Bottom only: rarely used, mainly for very short-striking fish in open water.
Hook size by jig weight
- 40 to 80 g jigs: 1/0 to 3/0.
- 100 to 160 g: 3/0 to 5/0.
- 180 to 250 g: 5/0 to 7/0.
- 300 to 400 g: 7/0 to 10/0.
Use stronger wire hooks for big amberjack, dogtooth tuna and grouper. See the fishing hook sizes chart.
Hook point direction
Rig the hook so the point faces toward the jig body, slightly inward. This helps the hook catch the fish's jaw and reduces snags.
Checking assists
- Check cords for fraying after every fish.
- Replace rusty or bent hooks.
- Keep points sharp: see how to sharpen fishing hooks.
Fish bite jigs on the fall more than on the lift. Watch your line for slack or a pause as the jig sinks, and wind down fast.
Identify your catch with ReelScan: snap one photo to get the species, size and safety notes, and earn points. Scan a fish.
Summary
Assist hooks sit at the top of the jig, reduce snags and hold fish better. Use twin assists for slow pitch, single or twin for speed jigging, keep cords short enough to avoid fouling, and size hooks to the jig weight. Put them to work with the vertical jigging guide and the slow pitch jigging technique.