How to Tie a Snell Knot: The Strongest Hook-to-Line Connection for Bait
Tie the snell knot step by step: why snelling a hook improves hook sets with bait and circle hooks, and common mistakes.
The snell knot ties line directly around the shank of a hook instead of through the eye. It creates a straight, in-line pull that sets hooks better, especially with bait and circle hooks. Snelling is one of the oldest and strongest ways to tie a hook, and it is still used by bait anglers, live bait specialists and offshore crews. This guide explains when to snell a hook and how to tie the snell knot step by step.
Why snell a hook
- Straight-line pull: the line comes off the shank in line with the point, so the hook rotates into the fish's jaw.
- Better hook sets with circle hooks, which rely on the hook turning into the corner of the mouth. See circle hooks vs J hooks.
- Strong knot, close to the full line strength when tied correctly.
- Two-hook rigs: you can snell a second hook on the same leader for long baits.
When to use it
- Live bait and dead bait rigs for snapper, grouper, tuna and sharks.
- Circle hook rigs for catch and release.
- Hooks with turned-up or turned-down eyes, where a normal knot pulls the hook off-line.
Do not snell hooks for lures or jigs; use a Palomar knot or an improved clinch knot.
How to tie a snell knot
Thread the line through the hook eye from the point side and lay 15 to 20 cm of tag along the shank toward the bend.
Bring the tag back toward the eye to make a loop beside the shank, and pinch the tag end and line at the eye.
Wrap the loop tightly around the shank and the tag, working from the eye toward the bend, 5 to 8 times.
Hold the wraps and pull the main line: the loop pulls in under the wraps.
Wet it, pull firmly while holding the hook, and trim the tag end close.
The line should now come out of the eye on the inside of the hook, the same side as the point.
Tips for a strong snell
- More wraps for thin line, fewer for thick leader.
- Keep the wraps neat, without crossing.
- Always moisten before tightening to prevent friction heat.
- Check that the line exits the front of the eye; if not, the hook will not rotate correctly.
Two-hook snell rigs
For long baits like squid, ballyhoo or mullet, snell a second hook 5 to 10 cm above the first on the same leader. The second hook catches fish that bite the front of the bait. See the live bait fishing guide.
Common mistakes
- Threading the eye from the wrong side.
- Wraps that cross over each other.
- Not tightening fully, so the knot slips under a big fish.
Tie a few spare snelled hooks on leaders at home. On the water, you just clip or tie them to the main line and keep fishing.
Identify your catch with ReelScan: snap one photo to get the species, size and safety notes, and earn points. Scan a fish.
Summary
The snell knot gives a straight pull from the shank, improves hook sets with bait and circle hooks, and holds very well. Tie it with 5 to 8 tight wraps, make sure the line exits the front of the eye, and use it for your bait rigs.