Skills & gear › Knots & rigs

How to Tie a Haywire Twist in Single Strand Wire

Make a haywire twist and barrel wrap in single strand wire for kingfish, wahoo and barracuda, and avoid the mistakes that make wire break.

The haywire twist is the standard way to attach a hook, swivel or lure to single-strand wire leader. It is the connection used for wahoo, king mackerel, barracuda and sharks, where sharp teeth would cut through mono or fluorocarbon. A correctly tied haywire twist keeps close to the full strength of the wire. A badly tied one can unwind or break. This guide explains every step.

When to use single-strand wire

For a full comparison of wire types, see the wire leader guide.

What you need

How to tie the haywire twist, step by step

  1. Pass the wire through the hook eye or swivel and pull about 10 cm through.
  2. Cross the two strands to form a small loop, holding the crossing point firmly between thumb and finger.
  3. Make the haywire wraps: twist BOTH strands around each other at the same time, so they spiral together like a twisted rope. The angle between them should be about 90 degrees, so both strands wrap evenly. Make 3 to 5 of these twists. This is the critical part. If only one strand wraps around a straight strand, the knot will slip.
  4. Make the barrel wraps: now bend the tag end at a right angle to the standing wire and wrap it tightly and neatly around the standing wire only, with each coil touching the last. Make 4 to 6 barrel wraps.
  5. Make a handle: bend the remaining tag end into a small L shape to use as a crank handle.
  6. Break off the tag: rock the handle back and forth (or crank it in a circle) until the wire breaks cleanly right at the last barrel wrap. This leaves no sharp burr.

Why you should not cut the tag

Cutting with pliers leaves a sharp point that can cut your hand, damage line, and snag weed. Breaking it off with the handle leaves a smooth end.

Common mistakes

  1. One strand wraps around the other instead of both twisting together. This produces a weak, slipping connection.
  2. Too few haywire twists. Use at least 3.
  3. Loose barrel wraps that spread apart.
  4. Kinking the wire during the twist. Kinked wire loses strength and should be replaced.

Connecting the leader to your main line

The other end of the wire usually gets a haywire twist to a barrel swivel. The main line or a mono leader then connects to the swivel with an improved clinch knot or uni knot.

Using a stinger rig

For king mackerel, a second treble hook is attached to the first with a short wire trace, both using haywire twists. The stinger hooks fish that bite the tail of the bait.

Practise the haywire twist at home with scrap wire. When you can tie ten in a row that do not slip, you are ready to tie them on a moving boat.

Identify your catch with ReelScan: snap one photo to get the species, size and safety notes, and earn points. Scan a fish.

Summary

The haywire twist is the right connection for single-strand wire. Twist both strands together 3 to 5 times, finish with 4 to 6 tight barrel wraps, and break off the tag with a handle. It protects your catch from sharp-toothed fish like wahoo, king mackerel and barracuda.

Related guides